b'Frame Out -Destructive Tear OutMetal Windows It is imperative that some continuity be restoredMetal windows are often buried behind siding that using liquid flashing, or adhesive-backed flashing towas installed during new construction or a previous repair the opening. remodel of the home. J Channel was used to finishthe newer siding, and cutting back everything to A drip cap andexpose the windows fin can be an expensive some functionalapproach. If the decision is for a Frame-Out, then a sill pan shoulddestructive Frame-Out may be the only alternative. be created.This method is best when there is a large overhang or Cover the 4other architectural element on the home to limit the sides with cel-amount of direct rainfall on the new window. lular pvc ofMDF board,The operable sash and any fixed panels of glass are whichis removed down to the old frame - sill, header and sealed to thejambs. A pry bar is used to get under the sill, and old opening.using a wood block to avoid damage to the interiorfinish, the sill of the old window is pried up, the The bottom header pried down, and the jambs in from the side. line is to beThis collapses the window into the opening so it can sure that waterbe removed. Prying the old frame, in essence, tears is diverted,the mounting fin of the old window out of the space drained andbetween the framing and the siding - destroying the dried to effect acontinuity of the old flashing. weather resistive installation.Liquid Flashing onexposed edgesDrip CapCellular pvcPry-Out Old blocking Frame Using for support Compressed Wood Block Foam Tapeto PreventTrim Damage Adhesive-backedflashing integrated with existing flashingAdhesive-backedflashing for effective sill panWhether its stucco, panel or lapped siding, prying out of the old frame is basically the same, requiring similar repairs.Window Fitters Guide to Window Installation392020 AWDI, LLC Do not reproduce without permission'