b'Sill Pans and Flashing Step 1: Step 3:Using Adhesive-backed Using adhesive-backedFlashing Material place flashing material (Vycorflashing over rough sill or equal) place flashingextending 5 inches around each jamb,down the front, and 4 overlapping the sillinches up each side. flashing.Be careful not to tear or Place adhesive-backedbuckle the membrane.flashing across theNOTE: If youre not header extending upusing a pre-formed sill and over the jambpan, you can create the flashing.effect by installing a 1 x 2 to create a backdam before applying the flashingStep 1 Step 3Step 2: Alternate 1:Assemble Sill Pan If house wrap has been(Jam-Sill or equal) to fit applied to the wall between the jambs and prior to beginning set on top of the sill. the window or doorDo not anchor theinstallation (Method B),sill pan to the roughcut the house wrap insill with fasteners as such a way to be abledoing so will createto fold it back, and tapea leak path. it out of the way.Fix the sill pan toFlashing materialseach jamb using the must adhere directly head of a roofing nail, to the sheathing for as shown below. maximum bond.If adhered to house-wrap, flashing maydirect water under thewrap and into the cavity between the window or door and the rough opening.Step 2 Alternate 1Alternate 2 and 3:If the house wrap has been moved aside, it cannow be un-taped and placed over the secondlayer of self-adhesive flashing to complete theinstallation.Again, take care to leave the bottomfree for drainage into the drainage plane.(See full detailed steps in the New ConstructionInstallation section elsewhere in this manual). Alternate 2 Alternate 3Window Fitters Guide to Window Installation202020 AWDI, LLC Do not reproduce without permission'