b'Step 7:Using proper Shimscrew or equal anchors,set jamb anchors andheader anchors.Adjust anchors to shimto plumb and level.Anchor the oppositejamb and re-checkplumb and square.Adjust as necessary.Step 7Step 8:You can use exterior snap trim or otherPhotos courtesy of Illbruckfinish trim to coverthe exposed impregnated slowexpansion foam tape on four sides.Caulk joint betweentrim and windowas necessary.There is no need tocaulk/seal the jointbetween the slowexpansion foam tapeand the block opening as the stucco finish will provide the proper joint finish.If no stucco is to be applied, most foam tapes will stand up to direct Step 8weather very well. Photos courtesy of HannoWindow Fitters Guide to Window Installation922020 AWDI, LLC Do not reproduce without permission'