b'Basic Installation1. As in most replacement situations, blind stops are 2. Caulk around the inside of the blindstops and layrecommended. This provides a firm surface to mount a bead of caulk approximately in the middle of wherethe window against, and assures weathertightness. the window will rest on the buck.Install blindstops of 1/2 x 3/4 stop material or1/2 quarter-round moulding. Set the stops 1/2 3. Insert the locked window into the opening fromfrom the outside edge of the installed buck. inside the house. 1/2" x3/4 BlindStops4. Check plumb and square with a level, and5. Using 1/8 drill bit, drill pilot holes through themeasure the diagonals to see if the window isinstallation hole into the wood buck. Mount the square. Adjust shims if necessary. Placewindow with screws provided in the hardware kit.insulation between frame and opening.Caulk UseFlatShims6. Put finishing trim around theinside of the window and caulk theperimeter. Finish off the wood andmoulding with a quality stain orpaint.Shim as necessary making sure toshim on both sides behind theinstallation screw holes. On top,shims must be placed directly overthe locks to maintain proper clear-ance between header and sash to assure proper windowoperation.Window Fitters Guide to Window Installation762020 AWDI, LLC Do not reproduce without permission'